Software update for programming box 2110035 and 2110052 and V3.0 speed controller 2110050.
Update to Revenge CTS 10 V3.1 – from April 2021.
Attention: Do not use for older speed controllers (V1, V2)!
For the update you need the program “DATA LINK” , the corresponding software and a USB interface cable (2110037).
After downloading and installing the Absima “DATA LINK” program, you must also download the corresponding software.
Start the Absima “DATA LINK” program and select the device to be programmed at the bottom left under Device Link.
Connect the blue socket of the programming box/controller’s programming port to the USB Interface Adapter which in turn is connected to your computer.
An LED on the interface adapter should now light up green.
Then press the “connect” button in the Data Link program – Connection Status. Both lamps in the program should now switch from red to green.
Now select in the area “Available Firmware” the software ProBox_0D430103 for the programming box or Absima_CTS10_V3_0D458203 for the controller and then press the button “Update”.
The process is completed after the “Device Status” lamp has blinked red once. Now press the “Disconnect” button and disconnect the programming box from the computer.